Showers & Immersion Heaters

We supply & install a range of new showers including the plumbing. We also repair and replace existing shower units & renew immersion heater elements & thermostats.

We can supply shower units in sizes from 7kw - 10.8kw from various manufacturers including Hotpoint, Mira & Triton.

Accreditation's

Under the "Domestic Installer Scheme" showers must be installed by competent persons & comply with BS7671 & Part P of the Building Regulations. We will carry out the installation, testing & Local Building Control notification as required by law.

Showers & Immersion Heaters

The size of the shower to be installed depends on the size of the electricity supply to the property. We can replace the existing cable & the protective device if a larger replacement shower is required. Call us for advice or a free quotation on 01584 810 286.

Generally a higher wattage shower will give a greater hot water flow.

Instantaneous Showers require a cold water feed with good mains pressure but there are versions with integral pumps for tank fed supplies.

Power inputs range from 7kw - 10.8kw and heat the water as it flows over the element.

Power Showers require a hot & cold feed from the tank & cylinder. They have either a built-in or separate pump. There is no heating element so they require only a small electricity supply.

Contact us for more information.